Fixed Height Steel Racing Jack Stands, Set of 4

Fixed height jack stands for vehicle repair work or vehicle storage needs. Fully welded steel bodies with black powder coat finish. 15x9.5-inch flat steel base plate provides support on soft/loose surfaces. 12-inch height provides working room for suspension and brake service. Each jack stand supports 3,000 lbs (1.5 tons) to keep you safe. Sold as a set of four to provide lift support for all four corners of your vehicle. Fixed Height Jack Stands Provide a Safe and Stable Work Surface Anywhere You Need Typical jack stands for car or truck use utilize a small base profile, usually just four small V-shaped corners, which are prone to digging into soft surfaces like asphalt, gravel, and especially packed dirt. These corners settle into the soft surface you are working on and cause the jack stand to provide less support than required to work safely. Often, this situation will lead to a jack stand tipping over and shifting the vehicle’s weight suddenly and dangerously. We’ve seen people place plywood or other materials under these car lift stands to use them on a soft/unstable surface, but this type of jack stand should only be used on a smooth and solid surface like a concrete driveway or shop floor. If you need to setup a vehicle for adjustment or repairs (or even short term storage) on anything but concrete, you need a much wider and more stable jack stand base. Using something like our fixed height racing jack stands is the safe way to handle these needs. The 15-inch x 9.5-inch flat mounting base provides 142 square inches of surface area to spread the weight the jack stand is supporting (up to 3,000 pounds or 1.5 tons for each stand!). This means that the jack stand will be very stable and not sink into hot/soft asphalt or loose dirt/gravel work areas, making them perfect for trackside pit work on your race car too! With a fixed height of 12 inches these racing jack stands are perfect for most wheel and tire, suspension, or brake work and can be used for under-car work as well. The jack stand’s 2-inch-wide upper cross bar is made from the same .105-inch thick steel (equivalent to 12-gauge) as the base and risers and provides a wide surface area for your chassis to safely rest on vs the typical jack stand’s narrow saddle. The fully welded heavy duty jack stand has no moving parts to fail either like the potential of an adjustable jack stand’s ratcheting lock lever, which is often retained by nothing more than a roll pin. These are packaged as a heavy duty jack stand kit of four ready to use for your race car or project vehicle. We offer our fixed height racing jack stands in aluminum if you’re looking for something a bit lighter to handle your jack stands for car or truck support needs. However, they do have a lower weight capacity. Finally, if you wish to provide a neat and secure storage space for your fixed height racing jack stands in your shop or enclosed trailer, be sure to look at our fixed height jack stand storage bin.

• Wide Base Stability: Large 15" x 9.5" flat steel base provides 142 sq. in. of contact area to prevent sinking on hot asphalt, gravel, or loose dirt surfaces
• Fixed Height Design: 12-inch working height offers ideal clearance for suspension, brake, wheel, and under-car service without moving parts or ratcheting mechanisms
• Heavy-Duty Construction: Fully welded steel bodies made from .105-inch thick material with a 2-inch wide cross bar for secure chassis support
• High Load Capacity: Each jack stand supports up to 3,000 lbs (1.5 tons), providing safe and dependable support for vehicles during service or storage
• Track & Shop Ready: Gloss black powder-coated finish resists wear; sold as a set of four for stable support at all four vehicle corners